Replacement engine on a pallet with oil pump, timing kit and water pump at JDM of San Diego

Engine Replacement Cost: Parts, Labor & Real Price Ranges by Make

Engine replacement cost swings a lot, and the first quote you get probably leaves things out. The engine is only one piece. Labor, installation parts, freight, and sometimes a California inspection all hit the final bill. This guide breaks each piece down so you can compare quotes fairly and decide if the repair makes sense.

How much does it cost to replace an engine?

Most of the total comes from two things: the engine and the labor to install it. The ranges below come from outside sources, so treat them as market ranges, not shop prices.

Cost piece

Market range

Source

Labor (15 to 25+ hours at $100 to $150 an hour)

About $1,500 to $3,750

CoverageX, April 2026 

Rebuild, all in

$2,500 to $4,000

Synchrony citing ConsumerAffairs, Aug 2025

Rebuild, all in

$3,500 to $6,000

Kelley Blue Book, July 2025

The engine itself

Depends on type

See live listings


What the engine itself costs

Price depends on the type you pick. Used and salvage engines cost the least. JDM imports usually sit close behind. Rebuilt and remanufactured engines cost more, and brand new engines cost the most.

Shops usually quote a long block, so ask whether the price includes the intake, sensors, and other outside parts. A cheap quote may just cover less. For a real example, look at the JDM K24A RBB for the TSX and check its current price on the page.

Freight, core charges, and pickup

Engines ship as palletized freight, so shipping adds to the total. You’ll see the cost at checkout or get a quote. You can also pick up for free at the Chula Vista shop. Some sellers add a core charge, which is a deposit you get back when you return your old engine. Ask before you order. The shipping policy covers delivery details.

Labor: hours, shop rates and why they vary

Shops bill engine swaps by book hours, also called flat rate hours. A labor guide sets the number for each car. CoverageX says a swap often runs 15 to 25 hours or more, while Synchrony cites 15 to 20 hours.

Several things push the hours up:

  • A V6 or a boxer engine takes longer than a simple four-cylinder

  • All Wheel Drive adds work

  • Seized or rusted bolts slow everything down

Hourly rates differ by shop and area, so get at least two written quotes in San Diego. Ask each shop for the book hours in writing.

Install parts most first quotes leave out

Here’s where quotes tend to grow. A new engine goes into an old car, so shops replace parts that touch it. Some warranties also require them.

Part

Why it’s replaced

Required by JDM of San Diego’s warranty?

Oil pump and oil system flush

Old debris can damage the new engine

Yes

Timing belt or chain and tensioner

Easy to reach now, costly to redo later

Yes

Water pump, thermostat, hoses, radiator flush

Overheating kills new engines

Yes

Gaskets and seals

Old ones leak

No

Motor mounts

Worn mounts cause vibration

No

Spark plugs, filters, fluids

Normal service

No

Prices vary by car, so ask your shop to list each part. Then compare that list against the warranty install requirements before you buy.

Engine replacement cost by make and model

Your engine code matters more than your model name. Confirm it before you order. The table shows common codes and the options we list for each. Check each product page for current prices and ask your shop for book hours.

Model

Engine code

Option listed

Acura TSX

K24A

JDM

Honda CR-V 2002 to 2006

K24A1

Remanufactured

Honda Accord 2008 to 2012

2.4L

Remanufactured

Accord, Odyssey, Pilot

J35Z

JDM

Toyota Camry, RAV4

2AR-FE

Brand new

Kia Soul 2017 to 2019

G4NC

Brand new

If you drive a Camry or RAV4, the brand new Toyota 2AR-FE is one option to price.

Used vs. JDM vs. remanufactured vs. new: cost vs. risk

Lower price usually means higher risk. Used and JDM engines cost less but carry shorter warranties. Remanufactured and new engines cost more, yet they often come with longer coverage. So the cheapest engine isn’t always the cheapest repair.

Drivers who want zero miles and a longer warranty may like the brand new Kia Soul 2.0L engine.

Rebuild vs. replace: which costs less?

It depends on what failed. A head gasket problem is a different job than a spun bearing or crank damage. Timing failures can fall anywhere in between. Kelley Blue Book puts rebuild costs at $3,500 to $6,000 (July 2025), so a used or JDM replacement can come out lower. Get a diagnosis first, then compare.

Is it worth replacing the engine?

Sometimes yes, sometimes no. Walk through these steps:

  • Check the car’s market value on Kelley Blue Book or Edmunds

  • Look at the transmission, body, and suspension

  • Think about how long you plan to keep it

  • Compare the total quote to the price of a replacement car

Engine swap cost (a different engine)

A swap to a different engine adds mounts, wiring, ECU work, and tuning. In California, it may also need a BAR referee inspection.

California costs: smog check and BAR referee

California has rules for engine changes. The Bureau of Automotive Repair says the replacement generally needs to match the same or a newer model year and the same vehicle class. It also needs all emissions equipment and OBD II support, and engine changes may need a referee inspection. Verify the current rules with BAR before you buy, because a like-for-like swap may not always need one. We can’t guarantee a smog pass.

Ways to lower the total bill

You can trim the cost in a few ways:

  • Confirm the engine code before ordering

  • Compare quotes on the same basis, long block or complete

  • Reuse good accessories

  • Pick up in Chula Vista to skip freight

  • Get book hours in writing

  • Order install parts up front

Engine replacement cost FAQs

How much should it cost to replace a car engine? 

Market sources put labor around $1,500 to $3,750, plus the engine and install parts.

Is it worth replacing the engine in a car? 

It can be, if the rest of the car is solid and you’ll keep it a while.

Is it cheaper to fix an engine or replace it? 

It depends on the failure. Minor repairs cost less, but major damage often favors replacement.

Is it cheaper to rebuild an engine or buy a used one? 

Used often costs less upfront, though a rebuild may carry a better warranty.

What is the labor cost to replace an engine? 

CoverageX cites 15 to 25+ hours at $100 to $150 an hour (April 2026).

Is a JDM engine cheaper than a used U.S. engine? 

Often, but compare mileage, warranty, and fit.

Want a real number for your car?

Send us your VIN and engine code. We’ll quote the engine, freight to your shop (or free pickup in Chula Vista), and exactly what’s included. Browse engines to see what’s in stock.


Back to blog